A small section has to be cut out of the bell housing to let it clear the passengers footwell.
A new cover plate was made to stop rubbish going into the bellhousing, this was made of 1mm steel.
Now ready to go into the chassis. Most of the bolts line up between the gearbox and the zetec but a few things needed to be changed prior to mating the two.
A new cover plate was made to stop rubbish going into the bellhousing, this was made of 1mm steel.
Now ready to go into the chassis. Most of the bolts line up between the gearbox and the zetec but a few things needed to be changed prior to mating the two.- Check for manual trigger sensor
- Pinto spigot bearing
- Extended release bearing
- DOHC starter
- Modified cover plate
- Bellhousing Cut out
- May aswell fit a new clutch while the engine is out (Got a brand new one for £10, good old ebay)
- 1.8 escort flywheel if you want to save 1.5 kg
